About Us

TRB Battery is a factory-direct supplier of e-bike battery packs, hub motor conversion kits, and the small parts that make a build work. We focus on one thing: getting the right voltage, capacity, and connector into your frame without the guesswork.

What We Sell

Our range covers three groups:

  • Battery packs — triangle and hardcase packs from 48V to 72V, 20Ah to 70Ah, for commuter builds through to high-power off-road projects.
  • Conversion kits — hub motor kits from 1500W to 5000W, matched to common wheel sizes.
  • Replacement parts and accessories — torque arms, disc brake spacers, foot pegs, seats, and seat covers.

Browse battery packs or conversion kits to see current options.

Choosing the Right Voltage and Capacity

Three numbers decide whether a pack works in your build:

  • Voltage (48V / 52V / 60V / 72V) — must sit inside your controller and motor limits. Higher voltage means more speed potential and lower current for the same power.
  • Capacity (Ah) — this is your range. A 20Ah pack roughly doubles the distance of a 10Ah pack on the same bike.
  • Continuous discharge (A) — must cover your controller's peak draw, or the BMS will cut out under load.

If you are unsure, send us your motor wattage, controller rating, wheel size, and the available frame space. We will tell you what fits before you order.

Fitment and Compatibility

Triangle packs are shaped to sit inside the frame triangle, which keeps weight low and centred. Hardcase packs suit racks and rear mounts. Before ordering, check:

  • Inside dimensions of your frame triangle or mounting area
  • Connector type and polarity on your controller
  • Discharge connector rating (XT60, XT90, and similar are not interchangeable under load)

Spec sheets on each product page list the dimensions, connector, and discharge rating.

Quality and Testing

Every pack is built from graded cells and tested before it leaves the bench. Two stages:

Cell intake inspection

  • Capacity grading — each incoming cell batch is capacity-tested, and only cells within spec go into packs.
  • Internal resistance matching — cells are matched by internal resistance so a pack discharges evenly instead of dragging its weakest cell down.
  • Voltage and visual screening — open-circuit voltage is checked and any cell with damage, swelling, or leakage is rejected.

Finished pack testing

  • Capacity verification — the assembled pack is charge/discharge cycled to confirm it meets its rated Ah.
  • Internal resistance measurement — measured at the pack terminals, not just at cell level.
  • Overcharge protection test — the BMS must cut off charging at the specified limit.
  • Over-discharge protection test — the BMS must cut off load before cells drop below their safe floor.

Our packs carry UN38.3 transport certification and CE compliance. Test reports and certification documents are available on request — just ask before you order.

Warranty and Returns

Every battery pack and conversion kit is covered by a 12-month warranty from the date of delivery. If a fault is caused by a manufacturing defect or a component failure under normal use, we repair or replace it.

Returns: we do not accept returns and we do not issue refunds. Because every pack is built to order, we cannot take goods back once they have shipped. If your item arrives damaged or develops a genuine fault, it is handled as a warranty replacement under the 12-month warranty below — not as a refund. Full terms: Warranty Policy · Refund Policy.

What the warranty does not cover

  • Physical damage — impact, crushing, punctured cells, or damage from a crash.
  • Water ingress — packs are not warranted against immersion or water damage.
  • Over-discharge damage — a pack left flat or stored uncharged for long periods can drop below recovery voltage. This is preventable: store at partial charge and top up regularly.
  • Disassembly or modification — opening the case, bypassing or replacing the BMS, or rewiring the pack voids the warranty.
  • Mismatched equipment — damage from a controller, motor, or charger outside the pack's rated voltage, current, or connector specification.
  • Normal capacity fade — all lithium cells lose capacity gradually with cycles and age. Gradual loss of range is not a defect.

Warranty claims need your order number, a description of the fault, and photos or a short video. That is usually enough for us to approve a replacement without shipping anything back.

Shipping and Lead Times

We ship worldwide. There is no country exclusion list — if you have a delivery address, we can ship to it.

Lead times

  • Handling: orders leave the workshop within 10 days of payment.
  • United States: roughly one month (about 4 weeks) door to door.
  • Australia: roughly one month (about 4 weeks) door to door.
  • Other destinations: transit time varies by country. We will give you an estimate when you order.

Every order ships with a tracking number. Lithium batteries travel under UN38.3 classification, which can add a few days in transit and occasionally requires a signature on delivery.

Need Help Matching a Battery or Kit?

Send us four details and we will point you to the right part:

  1. Motor wattage and controller rating
  2. Wheel size
  3. Available frame space (length × height × width)
  4. The range or speed you are aiming for

Contact us

Lithium batteries are powerful and must be handled correctly. Always charge on a non-combustible surface, use the charger supplied with the pack, and never open or modify a battery case.